(a) Greater durability and longer life protects expensive equipment from rusting, thereby avoiding replacement & maintenance costs.

(b) Prevents repetitive repainting resulting in constant & regular need of additional cost on paint & labour.

(c) Life of topcoats prolonged as under surface rusting arrested.

(d) Topcoats retain desired quality for longer periods, as under surface rusting is arrested.

(e) As the viscosity is low (lower than paints / epoxies) the coverage is tripple making it economical. Additionally,
repeated coats are not required as durability is far greater making the use of this product extremely cost effective in the long run.

(f) Does not reduce the strength of Steel, in fact it enhances it by preventing formation of Rust.

(g) If applied as per instructions, it will protect surfaces upto 4-10 times more than conventional rust convertors. depending on number of coatings, surface conditions and the environment.

( i ) In case of RG being top coated by a compatible enamel / epoxy, the system is rust free for upto 4-5 times that of a conventional rust convertor.

( ii ) In case of RG being over coated by red oxide / another primer and then top coated by an enamel / epoxy / aluminum top coat, the system is rust free for at least 6-7 times more than that of a conventional rust convertor.

( iii ) And in case of RG being part of a multi coat system ie; 4 coats or more, the life span is between 8 to 10 times more than of a conventional rust convertor.

(h) Is cost effective as no solvent based thinner is required in case of thickening during prolonged storage – just addition of ordinary water, not exceeding the evaporated amount so as to make the primer free flowing as before.